[Free] 2017(Oct) Dumps4cert Testinsides Cisco 300-075 Dumps with VCE and PDF Download 1-10

Dumps4Cert 2017 Oct Cisco Official New Released 300-075
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/300-075.html

Implementing Cisco IP Telephony amp; Video, Part 2 v1.0

Question No: 1

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Assume that NANP is being used and 9 is used for PSTN access code Long distance national calls are preceded with 1.

How should the HQ Cisco Unified Communications Manager be configured for calls to 3XXX to be sent to the gatekeeper at 1 0 1 6 1 with PSTN backups?

  1. Configure a route pattern for 3XXX Assign this route pattern to a route list that points to two route groups The first route group contains the H 225 trunk The second route group contains the MGCP gateway with prefix digits 1 408555 for the outgoing called number.

  2. Configure a route pattern for 1#3XXX Assign this route pattern to a route list that points to a route group that lists the H 225 trunk as first choice and the MGCP gateway as a second choice.

  3. Configure a route pattern for 4085543XXX. Assign this route pattern to a route list that points to two route groups. The first route group contains the H 226 trunk The second route group contains MGCP gateway.

  4. Configure a route pattern for 3XXX Assign this route pattern to a route list that points to two route groups The first route group contains the H 225 trunk The second route group contains MGCP gateway with prefix digits 91 408554 for the called number.

Answer: A Explanation:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmcfg/b03rtgrp.html

#wpxref46617

Question No: 2

Which option configures the secondary dial tone option for SRST mode to let the users hear the dial tone for PSTN calls?

  1. voice service voip secondary dialtone 0

  2. call-manager-fallback secondary dialtone 0

  3. dial-peer voice 1 pots secondary dialtone 0

  4. ccm-manager secondary dialtone 0

Answer: B

Question No: 3

Which action configures phones in site A to use G.711 to site B but to use G.729 to site C?

  1. Configure Cisco Unified Communications Manager regions.

  2. Configure Cisco Unified Communications Manager locations.

  3. Configure transcoder resources in Cisco Unified Communications Manager.

  4. Configure a gatekeeper.

Answer: A

Question No: 4

What is the purpose of configuring a hardware-based MTP when deploying Cisco Unified Communications Manager?

  1. to allow for supplementary services such as hold, transfer, and conferencing

  2. when you need support for up to 24 MTP sessions on the same server and 48 on a separate server

  3. when you need the ability to grow support by using DSPs

  4. when you want to only use Cisco Unified Communications Manager resources

Answer: C

Question No: 5

You want to perform Media Control Gateway Protocol gateway maintenance. For this purpose, you disable Media Control Gateway Protocol gateway using the no mgcp command.

After you perform the maintenance, you want to enable the Media Control Gateway Protocol gateway. Which command should you use?

  1. enable mgcp

  2. mgcp

  3. mgcp enable

  4. mgcp yes

  5. activate mgcp

  6. mgcp active

Answer: B

Question No: 6

An engineer must resolve a call failure issue. When using RTMT, the engineer notices that the Location Bandwidth Manager-OutOfResources counter is showing a positive value.

Which option is the cause of the call failure?

A.

lack of audio bandwidth

B.

lack of video bandwidth

C.

lack of transcoding resources

D.

lack of audio or video bandwidth

E.

lack of conferencing resources

Answer: A

Question No: 7

Which two formats are supported by Cisco Unified Communications Manager to stream music on hold? (Choose two.)

A. G.711 B. G.729 C. G.723 D. G.722 E. G.728

F. Advanced Audio Codec

Answer: A,B

Question No: 8

Which command is needed to utilize local dial peers on an MGCP-controlled ISR during an SRST failover?

  1. ccm-manager fallback-mgcp

  2. telephony-service

  3. dialplan-pattern

  4. isdn overlap-receiving

  5. voice-translation-rule

Answer: A

Question No: 9

Assume that local route groups are configured. When an IP phone moves from one device mobility group to another, which two configuration components are not changed? (Choose two.)

  1. IP subnet

  2. user settings

  3. SRST reference

  4. region

  5. phone button settings

Answer: B,E

Question No: 10

What component acts as a user agent for both ends of a SIP call while Cisco Unified SIP SRST is providing failover during a WAN outage?

  1. B2BUA

  2. SIP server

  3. SIP proxy

  4. SIP SRST router

  5. SIP registrar

Answer: A

100% Free Download!
Download Free Demo:300-075 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 300-075 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE