[Free] 2017(Oct) Dumps4cert Testinsides Cisco 200-120 Dumps with VCE and PDF Download 151-160

Dumps4Cert 2017 Oct Cisco Official New Released 200-120
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/200-120.html

CCNA Cisco Certified Network Associate CCNA

Question No: 151 – (Topic 4)

What OSPF command, when configured, will include all interfaces into area 0?

A. network 0.0.0.0 255.255.255.255 area 0

B. network 0.0.0.0 0.0.0.0 area 0

C. network 255.255.255.255 0.0.0.0 area 0

D. network all-interfaces area 0

Answer: A

Question No: 152 – (Topic 4)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

The two exhibited devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? (Choose three.)

  1. The Manchester serial address is 10.1.1.1.

  2. The Manchester serial address is 10.1.1.2.

  3. The London router is a Cisco 2610.

  4. The Manchester router is a Cisco 2610.

  5. The CDP information was received on port Serial0/0 of the Manchester router.

  6. The CDP information was sent by port Serial0/0 of the London router.

Answer: A,C,E

Question No: 153 – (Topic 4)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

The network administrator requires easy configuration options and minimal routing protocol traffic. What two options provide adequate routing table information for traffic that passes between the two routers and satisfy the requests of the network administrator? (Choose two.)

  1. a dynamic routing protocol on InternetRouter to advertise all routes to CentralRouter.

  2. a dynamic routing protocol on InternetRouter to advertise summarized routes to CentralRouter.

  3. a static route on InternetRouter to direct traffic that is destined for 172.16.0.0/16 to CentralRouter.

  4. a dynamic routing protocol on CentralRouter to advertise all routes to InternetRouter.

  5. a dynamic routing protocol on CentralRouter to advertise summarized routes to InternetRouter.

  6. a static, default route on CentralRouter that directs traffic to InternetRouter.

Answer: C,F

Question No: 154 – (Topic 4)

Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)

  1. RAM

  2. NVRAM

  3. flash memory

  4. HTTP server

  5. TFTP server

  6. Telnet server

Answer: C,E

Question No: 155 – (Topic 4)

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?

  1. enable cdp

  2. cdp enable

  3. cdp run

  4. run cdp

Answer: C

Question No: 156 – (Topic 4)

Which type of EIGRP route entry describes a feasible successor?

  1. a backup route, stored in the routing table

  2. a primary route, stored in the routing table

  3. a backup route, stored in the topology table

  4. a primary route, stored in the topology table

Answer: C

Question No: 157 – (Topic 4)

If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.)

A. ip default-gateway 0.0.0.0

B. ip route 172.16.2.1 0.0.0.0 0.0.0.0

C. ip default-network 0.0.0.0

D. ip default-route 0.0.0.0 0.0.0.0 172.16.2.1

E. ip route 0.0.0.0 0.0.0.0 172.16.2.1

Answer: C,E

Question No: 158 – (Topic 4)

What is the effect of using the service password-encryption command?

  1. Only the enable password will be encrypted.

  2. Only the enable secret password will be encrypted.

  3. Only passwords configured after the command has been entered will be encrypted.

  4. It will encrypt the secret password and remove the enable secret password from the configuration.

  5. It will encrypt all current and future passwords.

Answer: E

Question No: 159 – (Topic 4)

Which command displays CPU utilization?

  1. show protocols

  2. show process

  3. show system

  4. show version

Answer: B

Question No: 160 – (Topic 4)

Which characteristics are representative of a link-state routing protocol? (Choose three.)

  1. provides common view of entire topology

  2. exchanges routing tables with neighbors

  3. calculates shortest path

  4. utilizes event-triggered updates

  5. utilizes frequent periodic updates

Answer: A,C,D

100% Free Download!
Download Free Demo:200-120 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 200-120 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE