[Free] 2017(Oct) Dumps4cert Testinsides Cisco 200-120 Dumps with VCE and PDF Download 131-140

Dumps4Cert 2017 Oct Cisco Official New Released 200-120
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/200-120.html

CCNA Cisco Certified Network Associate CCNA

Question No: 131 – (Topic 4)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?

A. 192.168.1.1

B. 172.16.1.1

C. 1.1.1.1

D. 2.2.2.2

Answer: D

Question No: 132 – (Topic 4)

Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.)

Router(config)# router ospf 1

  1. All OSPF routers in an area must have the same process ID.

  2. Only one process number can be used on the same router.

  3. Different process identifiers can be used to run multiple OSPF processes

  4. The process number can be any number from 1 to 65,535.

  5. Hello packets are sent to each neighbor to determine the processor identifier.

Answer: C,D

Question No: 133 – (Topic 4)

Refer to the graphic.

Dumps4Cert 2017 PDF and VCE

A static route to the 10.5.6.0/24 network is to be configured on the HFD router. Which commands will accomplish this? (Choose two.)

A. HFD(config)# ip route 10.5.6.0 0.0.0.255 fa0/0

B. HFD(config)# ip route 10.5.6.0 0.0.0.255 10.5.4.6

C. HFD(config)# ip route 10.5.6.0 255.255.255.0 fa0/0

D. HFD(config)# ip route 10.5.6.0 255.255.255.0 10.5.4.6

E. HFD(config)# ip route 10.5.4.6 0.0.0.255 10.5.6.0

F. HFD(config)# ip route 10.5.4.6 255.255.255.0 10.5.6.0

Answer: C,D

Question No: 134 – (Topic 4)

What are two benefits of using a single OSPF area network design? (Choose two.)

  1. It is less CPU intensive for routers in the single area.

  2. It reduces the types of LSAs that are generated.

  3. It removes the need for virtual links.

  4. It increases LSA response times.

  5. It reduces the number of required OSPF neighbor adjacencies.

Answer: B,C

Question No: 135 – (Topic 4)

Which parameter or parameters are used to calculate OSPF cost in Cisco routers?

  1. Bandwidth

  2. Bandwidth and Delay

  3. Bandwidth, Delay, and MTU

  4. Bandwidth, MTU, Reliability, Delay, and Load

Answer: A

Question No: 136 – (Topic 4)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

The technician wants to upload a new IOS in the router while keeping the existing IOS.

What is the maximum size of an IOS file that could be loaded if the original IOS is also kept in flash?

  1. 3 MB

  2. 4 MB

  3. 5 MB

  4. 7 MB

  5. 8 MB

Answer: B

Question No: 137 – (Topic 4)

Which statements describe the routing protocol OSPF? (Choose three.)

  1. It supports VLSM.

  2. It is used to route between autonomous systems.

  3. It confines network instability to one area of the network.

  4. It increases routing overhead on the network.

  5. It allows extensive control of routing updates.

  6. It is simpler to configure than RIP v2.

Answer: A,C,E

Question No: 138 – (Topic 4)

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

  1. It requires the use of ARP.

  2. It can support multiple IPv6 subnets on a single link.

  3. It supports up to 2 instances of OSPFv3 over a common link.

  4. It routes over links rather than over networks.

Answer: B,D

Question No: 139 – (Topic 4)

Which command would you use on a Cisco router to verify the Layer 3 path to a host?

  1. tracert address

  2. traceroute address

  3. telnet address

  4. ssh address

Answer: B

Question No: 140 – (Topic 4)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

What is the reason that the interface status is quot;administratively down, line protocol downquot;?

  1. There is no encapsulation type configured.

  2. There is a mismatch in encapsulation types.

  3. The interface is not receiving any keepalives.

  4. The interface has been configured with the shutdown command.

  5. The interface needs to be configured as a DTE device.

  6. The wrong type of cable is connected to the interface.

Answer: D

100% Free Download!
Download Free Demo:200-120 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 200-120 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE