[Free] 2017(Nov) Dumps4cert Testinsides Cisco 400-201 Dumps with VCE and PDF Download 1-10

Dumps4cert 2017 Nov Cisco Official New Released 400-201
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4cert.com/400-201.html

CCIE Service Provider Written Exam (V 4.1)

Question No: 1

On which two protocols is VNC based? (Choose two)

  1. Rdesktop

  2. Terminal Services Client

  3. TCP

  4. RFB

  5. UDP

  6. CoRD

Answer: C,D

Question No: 2

Which two sets of configuration implements CBTS? (Choose two)

  1. Create multiple MPLS TE from the same headend to the same tail-end

  2. Assign a policy-map defining a CBWFQ on an MPLS TE tunnel

  3. Create a master tunnel to which other tunnels can be members

  4. Create two bandwidth pools a global pool and a pool

  5. Create a PBR to use multiple MPLS TE tunnels according to the EXP value

Answer: A,C

Question No: 3

which option describes how NFV, OpenStack, and KVM relate to each other ?

  1. OpenStack and NFV enable KVM

  2. OpenStack and KVM can be used to provide NFV

  3. NFV and KVM are based on OpenStack

  4. OpenStack and KVM are not related to NFV

Answer: A

Question No: 4

Dumps4Cert 2017 PDF and VCE

A router has this error in the syslog message What issue has it reported ?

  1. The BGP label 3 can be used only in a BGP VPNv4 update for a directly connected VPNv4 prefix of the sending PE router

  2. The BGP label 3 can be used only in a BGP VPNv4 update for multicast address-family

  3. The BGP label 3 can be used only in a BGP VPNv4 update if the RD is 0:0

  4. The BGP label 3 can be used as a label for a VPNv4 prefix

Answer: D

Question No: 5

A backbone carrier is approached by an ISP_A which provides L3VPN services. The ISP_A requires MPLS VPN services from the backbone carrier to establish connectivity between the two POPs of the ISP_A. Which label protocol should the backbone carrier use to provide the proper connectivity that the ISP_A requires?

  1. L2TPv3

  2. L2TPv2

  3. LDP

  4. GRE

  5. mGRE

  6. BGP

Answer: A

Question No: 6

An operations engineer identifies a device is receiving a section loss signal alarm for a SONET link. Which action does the engineer perform?

  1. Verify that the framing format on the port matches the format configured on the line

  2. Verify that the alarm exists on the remote site

  3. Verify that the light level for the POS interface is within acceptable limits

  4. Verify the line status at the remote end of the link

Answer: C

Question No: 7 DRAG DROP

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

PE1 and PE2 has a Layer 2 VPN over a GRE tunnel. This GRE tunnel built between P1 and P2 has LDP enabled. Consider a packet capture of the packets from CE1 and CE2 at P1 and R1 link. Drag the headers on the left and drop them on the right in the order of the encapsulation, starting from the inner header (at the top) to the outer header (at the bottom).

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Explanation:

Dumps4Cert 2017 PDF and VCE

C:\Users\tgt\Desktop\Data\Untitled.jpg

Question No: 8

Which three components are required to support ISSU? (Choose Three)

  1. Supported line cards.

  2. SSO and NSF working.

  3. Redundant router for failover.

  4. Images that are preloaded into the file system.

  5. Traffic that is moved to another device.

  6. Active and standby RPs.

Answer: A,B,F

Question No: 9

An engineer is tasked with configuring Lawful-Intercept on the Internet facing routers. Which two security issues must the engineer take into consideration? (Choose two)

  1. Encryption might be required depending on the request

  2. SNMPv2c should be enabled in order to provide the correct message format

  3. QoS and CoPP should be implemented to protect and optimize the tasks

  4. The communication between the MD and the Content IAP happens over UDP port 161

  5. Default SNMP does not include all the MIB interfaces needed to respond to the request

  6. A new and dedicated loopback interface is required to communicate with the MD device

Answer: D,E

Question No: 10

A design engineer has a requirement to implement QoS with a high degree of granularity in traffic management on a service provider network. The QoS behavior must match these requirements

*Shape multiple queues to a single rate

*Specify the maximum transmission rate of a set traffic classes that are queued separately

*Shape the aggregate traffic of queues on a physical interface

Which deployment meets these requirements ?

  1. RSVP

  2. LLQ

  3. CBWFQ with WRED

  4. hierarchical QoS

Answer: D

100% Free Download!
Download Free Demo:400-201 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4cert 400-201 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4cert IT Certification PDF and VCE