[Free] 2017(Nov) Dumps4cert Testinsides Cisco 400-151 Dumps with VCE and PDF Download 141-150

Dumps4cert 2017 Nov Cisco Official New Released 400-151
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4cert.com/400-151.html

CCIE Data Center (v2.0)

Question No: 141

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

ITD is configured as shown on a Cisco Nexus 7000 switch. Why is p.ng to VIP address still

not working?

  1. To ping VIP, you must add a probe to the device group.

  2. VIP must be from the same subnet as the ingress interface.

  3. Fail action is set to the wrong mode.

  4. This behavior is normal.

Answer: A

Question No: 142

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which command would produce this output?

  1. show stats probe type

  2. show stats HTTP

  3. show stats load balance

  4. show parameter map Answer: C

Question No: 143

Which three limitations or requirements do MP-BGP-based EVPN addresses have

compared to the initial IETF VXLAN standard (RFC 7348)? (Choose three.)

  1. Network flooding through protocol-based host MAC/IP route distribution and ARP suppression on the local VTEPs

  2. active-passive multihoming at Layer2

  3. requirement to disable multicast for underlay forwarding

  4. scalability limitations due to data-driven flood-and-learn behavior

  5. control-plane learning of end-host Layer 2 and Layer 3 reachability information, which provides integrated bridging and routing in VXLAN overla networks.

Answer: A,D,E

Question No: 144

Which option is the advantage of Cisco ACE SSL Offload?

  1. Export cipher suite

  2. Decentralized certificate management

  3. SSL encryption only

  4. Front-end SSL

Answer: D Explanation:

Ref: SSL Guide vA5(1.0)

Question No: 145

Which two options are advantages of deploying Ethernet-based FCoE switches such as the Cisco Nexus 7000 Series Switches beyond the access layer? (Choose two)

  1. lower overall throughput compared to native Fibre Channel switches

  2. flexibility to support file (NAS) and block (iSCSI and FCoE) storage traffic

  3. High-performance Ethernet-based FCoE switches cannot be used in a dedicated SAN core.

  4. requirement for traffic isolation with dedicated links and storage VDCs is no longer required.

  5. plans that include 40 and 100 Gigabit Ethernet speeds

Answer: B,E Explanation:

The other options right off are not advantages lower over throughput not and advantage, cannot be used in a dedicated SAN Core, and storage VDCs are required.

Ref:Cisco Nexus 7000 Series Switches:Ethernet Storage Directors Ref: Storage VDC On Cisco Nexus 7000 Series Switches

Question No: 146

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which two statements about this configuration command sequence with regards to the Cisco Nexus 5500 are true. (Choose two.)

  1. It configures this node to use 0EFC2A as the first 3 bytes of the FPMA.

  2. It configures this node to use 0EFC2A as the last 3 bytes of the FPMA.

  3. It configures this node to use FCID 0EFC2A to forward the FDISC to when an endpoint is connected.

  4. It reserves this FCID so only this node can use this FCID when communicating with other Fiber Channel entities.

  5. It permits this node to form FCoE ISLs only with other nodes configured for the same FC-MAP

Answer: A,C

Question No: 147

While doing service insertion with vASA with route peering, which two parts must be configured? (Choose two.)

  1. The path for interfaces must be specified when the L4-L7 device is created.

  2. The route peering profile must be specified when the L4-L7 Service Graph template is created.

  3. The VM name must be specified when the L4-L7 device is created.

  4. The chassis must be specified when the L4-L7 device is created.

Answer: A,B

Question No: 148

Which 2 span configurations on Nexus 1K are valid?

  1. switch# configure terminal switch(config)# monitor session # ?

    switch(config-monitor)# source interface ethernet 2/1-3 switch(config-monitor)# vlan 3, 6-8 tx

    switch(config-monitor)# filter vlan 3-5,7 switch(config-monitor)# destination interface eth 2/5

  2. switch# configure terminal switch(config)# monitor session # ?

    switch(config-monitor)# source interface ethernet 2/1-3 switch(config-monitor)# vlan 3, 6-8 tx

    switch(config-monitor)# filter vlan 3-5,7 switch(config-monitor)# destination interface eth 3/5

  3. switch# configure terminal switch(config)# monitor session # ?

    switch(config-monitor)# source interface ethernet 3/1-3 switch(config-monitor)# vlan 3, 6-8 tx

    switch(config-monitor)# filter vlan 3-5,7 switch(config-monitor)# destination interface eth 2/5

  4. switch# configure terminal switch(config)# monitor session # ?

    switch(config-monitor)# source interface ethernet 3/1 switch(config-monitor)# vlan 3, 6-8 tx

    switch(config-monitor)# filter vlan 3-5,7 switch(config-monitor)# destination interface eth 3/2

  5. switch# configure terminal switch(config)# monitor session # ?

switch(config-monitor)# source interface ethernet 2/1-4 switch(config-monitor)# vlan 3, 6-8 tx

switch(config-monitor)# filter vlan 3-5,7 switch(config-monitor)# destination interface eth 2/2

Answer: A,C

Question No: 149

Which Cisco UCS Director feature provides API information and API code generation capacities that make it easy to see and work with all the available APIs, including the REST APIs and the Java APIs?

  1. report metadata

  2. REST API Browser

  3. automation feature set

  4. orchestration feature set

Answer: B

Question No: 150

In a FabricPath network, known unicast traffic is sent with the outer destination address populated with the destination SID, SSID, and local ID. Which statement describes the outer destination address in the case of unknown unicast?

  1. The outer destination address is a reserved multicast MAC address known as MC1 (010F.FFC2.02C0).

  2. The outer destination address is a broadcast address (FFFF.FFFF.FFFF).

  3. The outer destination address is not required because FabricPath uses the FTag to forward unknown unicast.

  4. The outer destination address is a reserved multicast MAC address known as MC1 (010F.FFC1.01C0).

Answer: D

100% Free Download!
Download Free Demo:400-151 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4cert 400-151 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4cert IT Certification PDF and VCE