[Free] 2017(Nov) Dumps4cert Testinsides Cisco 300-360 Dumps with VCE and PDF Download 31-40

Dumps4cert 2017 Nov Cisco Official New Released 300-360
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4cert.com/300-360.html

Designing Cisco Wireless Enterprise Networks

Question No: 31

A customer has a business-critical voice network and wants to be alerted whenever voice clients move out of a coverage area and experience RSSI below -67 dBm on the 5 GHz band. Which option can be configured on the wireless controller to alert network administrators when this limit is surpassed?

  1. EDCA; voice optimized

  2. SIP voice sample interval

  3. 802.11a voice RSSI coverage threshold

  4. traffic stream metrics

Answer: C

Question No: 32

An engineer must design wireless coverage in thick-walled stairwells. Which information should the engineer refer to when determining where APs can be installed?

  1. Local or National Building Code

  2. IEEE

  3. BICSI TDMM

  4. Cisco Hardware Installation Guide

Answer: D

Question No: 33

A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping. How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

  1. No outer CAPWAP or inner QoS tagging is applied.

  2. The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.

  3. No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.

  4. The outer CAPWAP DHCP is marked and capped without any inner DSCP value.

Answer: B

Question No: 34

Refer to the exhibit.

While testing the post-deployment WLAN network, you discover that an AP has been placed in a difficult area.

The AP cannot be moved easily because of various requirements. The client performance of various Apple and Microsoft operating system-based products does not meet expectations. Which two options can help mitigate the performance issue? (Choose two.)

  1. Add additional APs.

  2. Increase the AP power level to maximum.

  3. Rotate the AP 90 degrees to change antenna polarity.

  4. Replace the AP with an AP and external antenna.

  5. Change the AP location to one that is less RF hostile.

Answer: A,D

Question No: 35

After the completion of a site survey with Ekahau Site Survey tool, using the default color

palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

  1. The area is below the minimum threshold configured on the tool.

  2. The area is below the detectable level and indicates no RF signal.

  3. The area is below -100 dBm at coverage cell edge.

  4. The area is below -67 dBm at coverage cell edge.

Answer: A

Question No: 36

An engineer is preparing for an outdoor wireless survey to mesh connect a distant remote building to a connected building. Which two types of antennas are appropriate for this application? (Choose two.)

  1. circular polarized

  2. patch

  3. dish

  4. Yagi

  5. omni

Answer: C,D

Question No: 37

What is the recommended minimum speed at the edge of the cells in an 802.11g network for a good Cisco VoWLAN deployment?

  1. 11 Mb/s

  2. 36 Mb/s

  3. 12 Mb/s

  4. 18 Mb/s

Answer: C

Question No: 38

An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?

A. 100

B. 250

C. 1000

D. 500

Answer: D Explanation:

You can order Cisco 5500 Series Controllers with support for 12, 25, 50, 100, 250 or 500 APs as the controller#39;s base capacity. You can add additional AP capacity through capacity adder licenses available at 25, 50, 100 and 250 AP capacities. You can add the capacity adder licenses to any base license in any combination to arrive at the maximum capacity of 500 APs.

Reference: http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-

controllers/112926-5508wlc-license.html

Question No: 39

A network engineer wants the DSCP marking to align with the 802.11e access category video. What will this marking be?

  1. 34

  2. AF31

  3. 4

  4. 5

Answer: A

Question No: 40

A Cisco 7925 phone at a client’s location is not registering with CUCM. The engineer analyzes a packet capture, sees that the phone receives an IP, and downloads the proper configuration file from TFTP successfully. What type of messages should the phone be sending at this point?

A. H.245

B. H.323

  1. MCGP

  2. SCCP

Answer: D

100% Free Download!
Download Free Demo:300-360 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4cert 300-360 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4cert IT Certification PDF and VCE