[Free] 2017(Nov) Dumps4cert Testinsides Cisco 300-207 Dumps with VCE and PDF Download 101-110

Dumps4cert 2017 Nov Cisco Official New Released 300-207
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4cert.com/300-207.html

Implementing Cisco Threat Control Solutions

Question No: 101

What Event Action in an IPS signature is used to stop an attacker from communicating with

a network using an access-list?

  1. Request Block Host

  2. Deny Attacker Inline

  3. Deny Connection Inline

  4. Deny Packet Inline

  5. Request Block Connection

Answer: A

Question No: 102 CORRECT TEXT

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Answer: Review the explanation part for full solution.

Explanation:

We need to define the parameter map, specifying port 8080 for http and https and define the servers and the license:

Branch-ISR#config t

Branch-ISR(config)# parameter-map type content-scan global

Branch-ISR(config-profile)#server scansafe primary name proxy-a.scansafe.net port http 8080 https 8080

Branch-ISR(config-profile)#server scansafe secondary name proxy-b.scansafe.net port http 8080 https 8080

Branch-ISR(config-profile)#license 0 0123456789abcdef

If the CWS proxy servers are not available, we traffic should be denied. This is done by the following configuration:

Branch-ISR(config-profile)#server scansafe on-failure block-all

Now we need to apply this to the fastethernet 0/1 interface outbound: Branch-ISR(config)#interface Fastethernet 0/1

Branch-ISR(config-if)#content-scan outbound

Branch-ISR(config-if)#exit Branch-ISR(config)#exit

Finally, we can verify out configuration by using the “show content-scan summary command:

Branch-ISR#show content-scan summary Primary: 72.37.244.203(Up)*

Secondary: 70.39.231.99 (Up) Interfaces: Fastethernet0/1

Question No: 103 CORRECT TEXT

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Answer: Review the explanation part for full solution.

Explanation:

We need to create a policy map named inside-policy and send the traffic to the CXSC blade:

ASA-FW# config t

ASA-FW(config)# policy-map inside-policy

ASA-FW(config-pmap)# policy-map inside-policy ASA-FW(config-pmap)# class class-default

ASA-FW(config-pmap-c)# cxsc fail-close auth-proxy ASA-FW(config-pmap-c)# exit

ASA-FW(config-pmap)# exit

The fail-close is needed as per instructions that if the CX module fails, no traffic should be allowed. The auth-proxy keyword is needed for active authentication.

Next, we need to apply this policy map to the inside interface: ASA-FW(config)#service-policy inside-policy interface inside. Finally, verify that the policy is active:

ASA-FW# show service-policy interface inside Interface inside:

Service-policy: inside-policy Class-map: class-default

Default QueueingCXSC: card status Up, mode fail-close, auth-proxy enabled Packet input 181, packet output 183, drop 0, reset-drop 0, proxied 0

Configuration guidelines can be found at this reference link:

Question No: 104

Which three zones are used for anomaly detection? (Choose three.)

  1. Internal zone

  2. External zone

  3. Illegal zone

  4. Inside zone

  5. Outside zone

  6. DMZ zone

Answer: A,B,C

Question No: 105

Which is the default IP address and admin port setting for https in the Cisco Web Security Appliance?

A. http://192.168.42.42:8080 B. http://192.168.42.42:80 C. https://192.168.42.42:443

D. https://192.168.42.42:8443

Answer: D

Question No: 106

Which five system management protocols are supported by the Intrusion Prevention System? (Choose five.)

  1. SNMPv2c

  2. SNMPv1

  3. SNMPv2

  4. SNMPv3

  5. syslog

  6. SDEE

  7. SMTP

Answer: A,B,C,F,G

Question No: 107

Which Cisco Cloud Web Security tool provides URL categorization?

  1. Cisco Dynamic Content Analysis Engine

  2. Cisco ScanSafe

  3. ASA Firewall Proxy

  4. Cisco Web Usage Control

Answer: D

Question No: 108

The Web Security Appliance has identities defined for faculty and staff, students, and default access. The faculty and staff identity identifies users based on the source network and authenticated credentials. The identity for students identifies users based on the source network along with successful authentication credentials. The global identity is for guest users not authenticated against the domain.

Recently, a change was made to the organization#39;s security policy to allow faculty and staff access to a social network website, and the security group changed the access policy for faculty and staff to allow the social networking category.

Which are the two most likely reasons that the category is still being blocked for a faculty and staff user? (Choose two.)

  1. The user is being matched against the student policy because the user did not enter credentials.

  2. The user is using an unsupported browser so the credentials are not working.

  3. The social networking URL was entered into a custom URL category that is blocked in the access policy.

  4. The user is connected to the wrong network and is being blocked by the student policy.

  5. The social networking category is being allowed but the AVC policy is still blocking the website.

Answer: C,E

Question No: 109

Which command disables SSH access for administrators on the Cisco ESA?

  1. interfaceconfig

  2. sshconfig

  3. sslconfig

  4. systemsetup

Answer: A

Question No: 110

Which feature of the Cisco Hybrid Email Security services enables you to create multiple email senders on a single Cisco ESA?

  1. Virtual Gateway

  2. Sender Groups

  3. Mail Flow Policy Connector

  4. Virtual Routing and Forwarding

  5. Email Marketing Connector

Answer: A

100% Free Download!
Download Free Demo:300-207 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4cert 300-207 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4cert IT Certification PDF and VCE