Implementing Cisco IP Routing
Question No: 211 – (Topic 7)
Which two authentication protocols does PPP support? (Choose two.)
Question No: 212 – (Topic 7)
Which traffic characteristic is the reason that UDP traffic that carries voice and video is assigned to the queue only on a link that is at least 768 kbps?
typically is not fragmented
typically is fragmented
causes excessive delays for video traffic
Question No: 213 – (Topic 7)
Refer to the exhibit. The command is executed while configuring a point-to-multipoint Frame Relay interface. Which type of IPv6 address is portrayed in the exhibit?
Question No: 214 – (Topic 7)
Refer to the exhibit. When summarizing these routes, which route is the summarized route?
A. OI 2001:DB8::/48 [110/100] via FE80::A8BB:CCFF:FE00:6F00, Ethernet0/0 B. OI 2001:DB8::/24 [110/100] via FE80::A8BB:CCFF:FE00:6F00, Ethernet0/0 C. OI 2001:DB8::/32 [110/100] via FE80::A8BB:CCFF:FE00:6F00, Ethernet0/0 D. OI 2001:DB8::/64 [110/100] via FE80::A8BB:CCFF:FE00:6F00, Ethernet0/0
Question No: 215 – (Topic 7)
To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)
C. ::192.168.30.1 D. C0A8:1E01:: E. 192.168.30.1:: F. ::C0A8:1E01
Question No: 216 – (Topic 7)
What are the default timers for RIPng?
Update: 30 seconds Expire: 180 seconds Flush: 240 seconds
Update: 20 seconds Expire: 120 seconds Flush: 160 seconds
Update: 10 seconds Expire: 60 seconds Flush: 80 seconds
Update: 5 seconds Expire: 30 seconds Flush: 40 seconds
Question No: 217 – (Topic 7)
Refer to following:
router eigrp 1
redistribute ospf 1 route-map ospf-to-eigrp default-metric 20000 2000 255 1 1500
route-map ospf-to-eigrp deny 10 match tag 6
match route-type external type-2
route-map ospf-to-eigrp permit 20 match ip address prefix-list pfx
set metric 40000 1000 255 1 1500
route-map ospf-to-eigrp permit 30 set tag 8
Which three statements accurately describe the result of applying the exhibited route map?
The map prohibits the redistribution of all type 2 external OSPF routes with tag 6 set.
The map prohibits the redistribution of all type 2 external OSPF routes.
The map redistributes into EIGRP all routes that match the pfx prefix list and the five metric values 40000, 1000, 255, 1, and 1500.
The map prohibits the redistribution of all external OSPF routes with tag 6 set.
All routes that do no match clauses 10 and 20 of the route map are redistributed with their tags set to 8.
The map permits the redistribution of all type 1 external OSPF routes.
Question No: 218 – (Topic 7)
Refer to the exhibit.
Routers R1 and R2 are IPv6 BGP peers that have been configured to support a neighbor relationship over an IPv4 internet work. Which three neighbor IP addresses are valid choices to use in the highlighted section of the exhibit? (Choose three.)
Answer: A,C,E Explanation:
The automatic tunneling mechanism uses a special type of IPv6 address, termed an “IPv4- compatible” address. An IPv4-compatible address is identified by an all-zeros 96-bit prefix, and holds an IPv4 address in the low-order 32-bits. IPv4-compatible addresses are structured as follows:
Therefore, an IPv4 address of 10.67.0.2 will be written as ::10.67.0.2 or 0:0:0:0:0:0:10.67.0.2 or ::0A43:0002 (with 10[decimal] = 0A[hexa] ; 67[decimal] = 43[hexa] ; 0[hexa] = 0[decimal] ; 2[hexa] = 2[decimal])
Question No: 219 – (Topic 7)
What is the administrative distance for EBGP?
Question No: 220 – (Topic 7)
Refer to the exhibit.
Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?
show ip route
Answer: D Explanation: Explanation
The “show route-map “route-map name” displays the policy routing match counts so we can learn if PBR reacts to packets sourced from 172.16.0.0/16 or not.
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|