[Free] 2017(Nov) Dumps4cert Testinsides Cisco 300-101 Dumps with VCE and PDF Download 161-170

Dumps4Cert 2017 Nov Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/300-101.html

Implementing Cisco IP Routing

Question No: 161 – (Topic 7)

Refer to Exhibit.

Dumps4Cert 2017 PDF and VCE

R1 is unable to ping interface S0/0 of R2. What is the issue the configuration that is shown here?

  1. The route-target configuration command is missing.

  2. The interface IP addresses are not in the same subnet.

  3. the syntax of the ping command is wrong.

  4. The default route configuration is missing.

  5. The serial interfaces belong to the global table instead of vrf Yellow.

Answer: D

Question No: 162 – (Topic 7)

Which two types of threshold can you configure for tracking objects? (Choose Two)

  1. percentage

  2. MTU

  3. bandwidth

  4. weight

  5. delay

  6. administrative distance

Answer: A,D

Question No: 163 – (Topic 7)

Which statement is true?

  1. RADIUS uses TCP, and TACACS uses UDP.

  2. RADIUS encrypts the entire body of the packet.

  3. TACACS encrypts only the password portion of a packet.

  4. TACACS separates authentication and authorization.

Answer: D

Question No: 164 – (Topic 7)

Refer to the exhibit. On the basis of the output from the show ipv6 interface command, what two statements must be true? (Choose two.)

Dumps4Cert 2017 PDF and VCE

  1. Interface Ethernet 0/0 was configured with the ipv6 ospf 1 area 1 command.

  2. Interface Ethernet 0/0 has been configured with the ipv6 ospf authentication ipsec spi 500 md5 command.

  3. OSPF version 3 is enabled to support IPv6.

  4. The IP address of the designated router (DR) is FE80::A8BB:CCFF:FE00:6E00.

  5. This is the designated router (DR) on the Ethernet 0/0 link.

    Answer: B,C

    Question No: 165 – (Topic 7)

    Given the network diagram.

    Dumps4Cert 2017 PDF and VCE

    Which address would successfully summarize only the networks seen?

    A. 192.168.0.0/24 B. 192.168.8.0/20 C. 192.168.8.0/21 D. 192.168.12.0/20 E. 192.168.16.0/21

  6. These networks cannot be summarized.

Answer: C Explanation:

let#39;s suppose it is a /20 then we would have addresses from 192.168.0.1 to 192.168.15.255

Now let#39;s suppose it is a /21 then we would have addresses from 192.168.8.1 to 192.168.15.255

So both summaries encompass the networks we want to summarize but the second one is the most restrictive one as it only encompasses the networks we were asked to summarize and not others so it is the correct summary.

In fact just count the number of subnets which is 8 and find the exponent of 2 which is 8, that gives you 3 and to find out the summary mask just do /24 – 3 = /21.

if you make it in binary you#39;ll find out the answer too: the interesting octet is 3rd one so let#39;s convert in binary. 8 0000 1000

9 0000 1001

10 0000 1010

11 0000 1011

12 0000 1100

13 0000 1101

14 0000 1110

15 0000 1111

I#39;ve bolded the bits in common there are 5 so 16 5=21 which is mask and address is 192.168.8.0

Question No: 166 – (Topic 7)

What following parameters for the EIGRP authentication need to match in order for EIGRP neighbors to establish a neighbor relationship?

  1. Autonomous System number.

  2. K-Values

  3. If authentication is used both: the key number, the password, and the date/time.

  4. The neighbors must be on common subnet (all IGPs follow this rule).

Answer: C

Question No: 167 – (Topic 7)

Which statement about the NPTv6 protocol is true?

  1. It is used to translate IPv4 prefixes to IPv6 prefixes.

  2. It is used to translate an IPv6 address prefix to another IPv6 prefix.

  3. It is used to translate IPv6 prefixes to IPv4 subnets with appropriate masks.

  4. It is used to translate IPv4 addresses to IPv6 link-local addresses.

Answer: B

Question No: 168 – (Topic 7)

Other than a working EIGRP configuration, which option must be the same on all routers for EIGRP authentication key role over to work correctly?

  1. SMTP

  2. SNMP

  3. Passwords

  4. Time

Answer: C

Question No: 169 – (Topic 7)

Which two attributes describe UDP within a TCP/IP network? (Choose two.)

  1. Acknowledgments

  2. Unreliable delivery

  3. Connectionless communication

  4. Connection-oriented communication

  5. Increased headers

Answer: B,C

Question No: 170 – (Topic 7)

A router was configured with the eigrp stub command. The router advertises which types of

routes?

  1. connected, static, and summary

  2. static and summary

  3. connected and static

  4. connected and summary

Answer: D

100% Free Download!
Download Free Demo:300-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 300-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE