[Free] 2017(Nov) Dumps4cert Testinsides Cisco 300-101 Dumps with VCE and PDF Download 121-130

Dumps4Cert 2017 Nov Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/300-101.html

Implementing Cisco IP Routing

Question No: 121 – (Topic 6)

What is the purpose of configuring the router as a PPPoE client?

  1. to provide VPN access over L2TP

  2. to enable PPP session from the router to the termination device at the headend for

    metroEthernet connectivity

  3. for DSL connectivity and removing the need for the end-user PC to run the PPPoE client software

  4. for connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system

Answer: C Explanation:

DSL Technology used PPPoE protocol (service provide end) and user end required to be used same Protcol running as client to communicate with it

Question No: 122 – (Topic 6)

A network engineer has left a NetFlow capture enabled over the weekend to gather information regarding excessive bandwidth utilization. The following command is entered:

switch#show flow exporter Flow_Exporter-1 What is the expected output?

  1. configuration of the specified flow exporter

  2. current status of the specified flow exporter

  3. status and statistics of the specified flow monitor

  4. configuration of the specified flow monitor

Answer: B

Question No: 123 – (Topic 6)

Which two methods of deployment can you use when implementing NAT64? (Choose two.)

  1. stateless

  2. stateful

  3. manual

  4. automatic

  5. static

  6. functional

  7. dynamic

Answer: A,B

Question No: 124 – (Topic 6)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Given the partial configuration in the exhibit, which IPv6 statement is true?

  1. The configuration is an example of an encrypted IPv6 VPN tunnel.

  2. The configuration is an example of a one to one IPv6 tunnel.

  3. The configuration is an example of a 6to4 tunnel.

  4. The configuration is an example of a 4to6 tunnel.

Answer: C

Question No: 125 – (Topic 6)

Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.

Which of the following answers best describes the router’s logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?

  1. When the packet received on the LAN interface is permitted by the ACL listed on the tunnel gre acl command under the incoming interface

  2. When routing the packet, matching a route whose outgoing interface is theGRE tunnel interface

  3. When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interface

  4. When permitted by an ACL that was referenced in the associated crypto map

Answer: B Explanation:

As for the correct answer, the process of routing a packet out a GRE tunnel interface triggers the GRE encapsulation action. As for the incorrect answers: There is no tunnel gre acl command. There is no IPsec tunnel interface. Finally, one answer refers to logic that would describe a router’s logic when determining whether to encapsulate a packet into an IPsec tunnel.

Question No: 126 – (Topic 6)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which statement about the output of the show flow-sampler command is true?

  1. The sampler matched 10 packets, each packet randomly chosen from every group of 100 packets.

  2. The sampler matched 10 packets, one packet every 100 packets.

  3. The sampler matched 10 packets, each one randomly chosen from every 100-second interval.

  4. The sampler matched 10 packets, one packet every 100 seconds.

Answer: A

Question No: 127 – (Topic 6)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which statement is correct regarding the operation of NAT-PT between the IPv4 and IPv6 networks shown?

  1. The router will determine the IPv4 destination address.

  2. The source IPv6 host can use DNS to determine the IPv6-to-IPv4 address mapping.

  3. The host is statically configured with the IPv6-to-IPv4 address mapping.

  4. ICMP can be used to determine the IPv6-to-IPv4 address mapping.

Answer: B

Question No: 128 DRAG DROP – (Topic 6)

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 129 – (Topic 6)

A network administrator uses GRE over IPSec to connect two branches together via VPN tunnel. Which one of the following is the reason for using GRE over IPSec?

  1. GRE over IPSec provides better QoS mechanism and is faster than other WAN technologies.

  2. GRE over IPSec decreases the overhead of the header.

  3. GRE supports use of routing protocol, while IPSec supports encryption.

  4. GRE supports encryption, while IPSec supports use of routing protocol.

Answer: C

Question No: 130 – (Topic 6)

IPv6 has just been deployed to all of the hosts within a network, but not to the servers. Which feature allows IPv6 devices to communicate with IPv4 servers?

  1. NAT

  2. NATng

  3. NAT64

  4. dual-stack NAT

  5. DNS64

Answer: C

Topic 7, Mix Questions

100% Free Download!
Download Free Demo:300-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 300-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE