[Free] 2017(Nov) Dumps4cert Testinsides Cisco 300-101 Dumps with VCE and PDF Download 11-20

Dumps4Cert 2017 Nov Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/300-101.html

Implementing Cisco IP Routing

Question No: 11 – (Topic 1)

Which statement about the use of tunneling to migrate to IPv6 is true?

  1. Tunneling is less secure than dual stack or translation.

  2. Tunneling is more difficult to configure than dual stack or translation.

  3. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.

  4. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.

Answer: C

Question No: 12 – (Topic 1)

A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

  1. IP routing

  2. FIB

  3. ARP cache

  4. MAC address table

  5. Cisco Express Forwarding table

  6. topology table

Answer: A,B

Topic 2, Layer 2 Technologies

Question No: 13 – (Topic 2)

Prior to enabling PPPoE in a virtual private dialup network group, which task must be

completed?

  1. Disable CDP on the interface.

  2. Execute the vpdn enable command.

  3. Execute the no switchport command.

  4. Enable QoS FIFO for PPPoE support.

Answer: B

Question No: 14 – (Topic 2)

A network engineer has been asked to ensure that the PPPoE connection is established and authenticated using an encrypted password. Which technology, in combination with PPPoE, can be used for authentication in this manner?

  1. PAP

  2. dot1x

  3. IPsec

  4. CHAP

  5. ESP

Answer: D

Question No: 15 – (Topic 2)

Which statement is true about the PPP Session Phase of PPPoE?

  1. PPP options are negotiated and authentication is not performed. Once the link setup is completed, PPPoE functions as a Layer 3 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

  2. PPP options are not negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 4 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

  3. PPP options are automatically enabled and authorization is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be encrypted over the PPP link within PPPoE headers.

  4. PPP options are negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

Answer: D

Question No: 16 – (Topic 2)

Which PPP authentication method sends authentication information in clear text?

  1. MS CHAP

  2. CDPCP

  3. CHAP

  4. PAP

Answer: D

Question No: 17 – (Topic 2)

A corporate policy requires PPPoE to be enabled and to maintain a connection with the ISP, even if no interesting traffic exists. Which feature can be used to accomplish this task?

  1. TCP Adjust

  2. Dialer Persistent

  3. PPPoE Groups

  4. half-bridging

  5. Peer Neighbor Route

Answer: B

Question No: 18 – (Topic 2)

PPPoE is composed of which two phases?

  1. Active Authentication Phase and PPP Session Phase

  2. Passive Discovery Phase and PPP Session Phase

  3. Active Authorization Phase and PPP Session Phase

  4. Active Discovery Phase and PPP Session Phase

Answer: D

Question No: 19 – (Topic 2)

Which protocol uses dynamic address mapping to request the next-hop protocol address for a specific connection?

  1. Frame Relay inverse ARP

  2. static DLCI mapping

  3. Frame Relay broadcast queue

  4. dynamic DLCI mapping

Answer: A

Topic 3, Layer 3 Technologies

Question No: 20 – (Topic 3)

Scenario:

You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running-config command.

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Dumps4Cert 2017 PDF and VCE

Which of the following statements is true about the serial links that terminate in R3

  1. The R1-R3 link needs the neighbor command for the adjacency to stay up

  2. The R2-R3 link OSPF timer values are 30, 120, 120

  3. The R1-R3 link OSPF timer values should be 10,40,40

  4. R3 is responsible for flooding LSUs to all the routers on the network.

Answer: B

100% Free Download!
Download Free Demo:300-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 300-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE