[Free] 2017(Aug) CollectDumps Pass4sure Cisco 500-006 Dumps with VCE and PDF 41-50

CollectDumps 2017 Aug Cisco Official New Released 500-006
100% Free Download! 100% Pass Guaranteed!
http://www.CollectDumps.com/500-006.html

Implementing Cisco TelePresence Video Solution, Part 2

Question No: 41 – (Topic 4)

A customer wants to allow users to create ad hoc conferences by dialing the Cisco TelePresence MCU service prefix of 8, followed by a number for the conference. Which global conference settings allow the customer to do this?

  1. Media port reservation: Disabled | Incoming calls to unknown conferences or auto attendants: Create new ad hoc conference | Register ad hoc conferences with gatekeeper: On

  2. Media port reservation: Enabled | Incoming calls to unknown conferences or auto attendants: Default auto attendant | Register ad hoc conferences with gatekeeper: Off

  3. Media port reservation: Enabled | Incoming calls to unknown conferences or auto attendants: Create new ad hoc conference | Register ad hoc conferences with gatekeeper: Off

  4. Media port reservation: Disabled | Incoming calls to unknown conferences or auto attendants: Default auto attendant | Register ad hoc conferences with gatekeeper: On

Answer: A

Question No: 42 – (Topic 4)

How do you know that all blades on the Cisco TelePresence MSE 8000 have booted correctly?

  1. The logo will light up.

  2. The lights on the fan tray will turn green.

  3. The light in the supervisor blade will turn green.

  4. Alarm lights come on.

Answer: B

Question No: 43 – (Topic 4)

Why would an endpoint stop sending 720p in a call with a Cisco TelePresence MCU?

  1. The endpoint Ethernet speed renegotiated at half-duplex.

  2. The Cisco TelePresence MCU is using video to receive bit rate optimization to request a lower bandwidth.

  3. Another endpoint joined the conference, which brought the conference rate down.

  4. Another endpoint failed in its negotiation with the Cisco TelePresence MCU.

Answer: B

Question No: 44 – (Topic 4)

Which three protocols does Cisco TelePresence Server support? (Choose three.)

A. SCCP B. H.323 C. H.460

  1. TIP

  2. SIP

Answer: B,D,E

Question No: 45 – (Topic 4)

What does an endpoint system use to navigate the Auto Attendant menu on the Cisco

TelePresence MCU?

  1. FECC and DTMF navigation

  2. a special remote that came with the Cisco TelePresence MCU

  3. only FECC, DTMF is not supported

  4. web interface of the endpoint

Answer: A

Question No: 46 – (Topic 4)

A Cisco 5310 MCU is being configured as an ad hoc conference bridge in Cisco Unified Communications Manager. Which two configuration steps must be completed for this to function correctly? (Choose two.)

  1. Install the Cisco Unified Communications Manager feature key on the MCU.

  2. Create a SIP trunk from Cisco Unified Communications Manager to the MCU.

  3. Enable Media Port Reservation on the MCU.

  4. Disable H.323 and enable SIP on the MCU.

Answer: C,D

Question No: 47 – (Topic 4)

When the administrator enables remotely managed mode on the Cisco TelePresence Server, which statement is correct?

  1. Cisco TelePresence Conductor can communicate with the TelePresence Server.

  2. Cisco TMS is able to gather CDR data.

  3. SNMPv3 is used as a secure communication channel to the management device.

  4. Cisco Unified Communications Manager can communicate with the TelePresence Server.

Answer: A

Question No: 48 – (Topic 4)

Which three methods can an engineer use to upgrade the software on the Cisco TelePresence MCU? (Choose three.)

  1. web interface

  2. FTP

  3. flash drive

  4. SSH

  5. serial interface

  6. RMA the unit

  7. Telnet

Answer: A,B,C

Question No: 49 – (Topic 4)

Which command is used to set the IP configuration for a Cisco TelePresence MCU?

  1. status lt;IP addressgt; lt;netmaskgt; lt;default GWgt; lt;DNS server addressgt;

  2. xconfigure lt;IP addressgt; lt;netmaskgt; lt;default GWgt; lt;DNS server addressgt;

  3. static lt;IP addressgt; lt;netmaskgt; lt;default GWgt; lt;DNS server addressgt;

  4. set lt;IP addressgt; lt;netmaskgt; lt;default GWgt; lt;DNS server addressgt;

Answer: C

Question No: 50 – (Topic 4)

What is required for Cisco TelePresence Server to communicate with Cisco WebEx, using the PSTN?

  1. Cisco TelePresence MCU 5300

  2. Cisco 3420 ISDN Gateway

  3. third-party interop key

  4. Web Conferencing feature key

Answer: C

100% Free Download!
Download Free Demo:500-006 Demo PDF
100% Pass Guaranteed!
Download 2017 CollectDumps 500-006 Full Exam PDF and VCE

CollectDumps ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 CollectDumps IT Certification PDF and VCE